Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Fontana, CA
Gate installation in Fontana runs headfirst into two things: block walls and Santa Ana wind. Most homes here are 1950s through 1980s tract builds where gates hang off cinder-block pillars or rusted steel posts set into sun-baked concrete. A new gate has to be anchored right or the first big wind storm loosens it. Kensington Gate Repair has served Fontana since 2011, and we size every installation around the lot, the wall, and how much wind that specific street actually catches. Call (833) 320-4513 for a free estimate.
Why Fontana Homes Are Different
Fontana’s housing stock tilts heavily toward post-war tract homes with wide concrete driveways and perimeter block walls, especially through 92335 and 92336. That means most gate work here is not ornamental estate ironwork. It’s aging steel driveway gates bolted into cinder block, vinyl gates on newer 92337 HOA lots, and plenty of wood gates that the Inland Empire sun has warped past easy adjustment.
The climate does its own damage. Hot, dry summers bake wood until it splinters and vinyl until it turns brittle. Santa Ana winds push hard against any gate with surface area, working hinge screws loose and bending lightweight frames. On Fontana’s east-side block-wall tracts, we regularly find original steel gate posts rusted clean through at the base where sprinkler overspray hits sun-baked block. It’s the first failure point our techs check. A gate that looks fine from street level can be one good wind gust away from dropping.
What that means for you: a gate installed or repaired in Fontana needs hardware and mounting methods built for heat, wind, and hard water. Generic hardware-store hinges do not survive out here. We see the results of that shortcut on service calls every week.
Styles & brands we work with
Our Main Fontana Services
Most Fontana calls to Kensington Gate Repair start with one of two problems: a gate that will not open or close properly, or an electric operator that stopped responding. Both live in this city’s specific conditions.
Gate Repair in Fontana
Fontana’s block walls and steel posts fail in predictable ways. Hinges pull out of weathered block, post bases rust through at ground level, and gate frames twist under years of Santa Ana wind. We rebuild and re-anchor what has failed, and we do it with hardware rated for this climate. Whether the gate drags on the concrete, sags at the latch, or will not swing at all, our techs diagnose the actual cause before touching a tool. Read the full breakdown on our Gate Repair in Fontana page.
Electric Gate Repair in Fontana
Automated gate systems in Fontana work harder than they should. Heat cycles stress control boards, wind forces the opener arm to strain against a gate that is already binding, and dust off the foothills gets into sensors and limit switches. Kensington Gate Repair are electric gate specialists. We fix motors, boards, loops, and safety sensors, and because we work across LiftMaster, DoorKing, Elite, and Mighty Mule systems, we diagnose by what fits your setup, not by what we happen to stock. Details are on our Electric Gate Repair in Fontana page.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Fontana
Gate installation in Fontana usually means replacing a gate that was installed decades ago for a different lot. The old steel frame has rusted at the welds, the block pillar has shifted, or the gate was never wide enough for today’s trucks and SUVs. Average daytime highs in the high 90s through summer and constant dry wind mean the wrong material or mounting choice fails fast. We anchor into the existing block or set new posts properly, and we quote the full job before starting. For a wider look at what a full gate installation involves, including material choices and layout, see our dedicated Gate Installation service page.
Automatic Gate Installation
Signs you need it
You are tired of getting out of the car to swing the gate open, or your existing manual gate is too heavy to operate smoothly by hand.
What it costs in Fontana
For a new automatic gate system in Fontana, budget $2,500 to $7,500 depending on gate size, operator type, and whether new electrical service is needed.
How we do it
We measure the driveway and gate span, check the mounting wall or posts, then install the operator, safety edges, and controls, wiring everything to code with the run fully tested.
Driveway Gate Installation
Signs you need it
The existing gate sags, drags on the concrete, or no longer closes square against the post, and repairs would cost more than a properly built replacement.
What it costs in Fontana
A new driveway gate in Fontana typically runs $2,000 to $6,000, with automatic operation adding the cost of the operator and power run.
How we do it
We pull the old gate, assess the block pillars or set new posts in concrete, then fabricate and hang the new gate with hardware matched to the gate’s weight and this area’s wind load.
What Gate Installation Costs in Fontana
| Item | Typical range in Fontana |
|---|---|
| Driveway gate (manual, single swing) | $2,000 – $4,000 |
| Automatic gate system with operator | $2,500 – $7,500 |
| Gate installation labor (per gate) | $500 – $1,000 |
Prices above reflect the most common Fontana jobs. Every quote is written and agreed before work starts, so the number you approve is the number you pay.
Does Fontana require a permit for gate installation?
Permit requirements in Fontana depend on the gate’s height, location, and whether electrical work covers the operator. We check local code for your specific project before quote and handle the paperwork where required.
How long does gate installation take in Fontana?
Most single driveway gate installations finish in one day once materials are on site. Automatic systems with a new power run may take a second day for final wiring and safety testing. Call (833) 320-4513 for a realistic timeline for your gate.
Brands We Service in Fontana
We work on virtually every major gate brand you are likely to have in Fontana: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. Because we are brand-agnostic, we diagnose against what your system actually needs, not against what one manufacturer pushes. See our brands for more on the systems we service daily in Fontana.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Fontana, CA
| Service | Typical range in Fontana |
|---|---|
| Gate repair (minor hinge or latch) | $150 – $350 |
| Gate repair (major frame or post work) | $350 – $900 |
| Electric gate repair (control board) | $250 – $700 |
| Electric gate repair (operator motor) | $400 – $1,200 |
| Automatic gate installation | $2,500 – $7,500 |
| Driveway gate installation | $2,000 – $6,000 |
| Gate installation labor (per gate) | $500 – $1,000 |
| Service call and diagnostic | $75 – $120 |
What pushes gate pricing up in Fontana is usually the wall, not the gate. Block pillars that have shifted, posts rusted at the base, or an old electrical run that needs replacement all add scope. We always quote the complete job up front, in writing, before any work begins.
Neighborhoods We Serve in Fontana
Kensington Gate Repair covers the full Fontana area, including the 92334, 92335, 92336, and 92337 ZIP codes. We work throughout the older tract neighborhoods and newer HOA communities alike.
- Downtown Fontana and the older blocks around Sierra Avenue
- The postwar tracts through 92335 and 92336
- Newer 92337 HOA communities with vinyl and metal gates
- North Fontana neighborhoods off Summit Avenue
- East-side block-wall tracts where rusted post bases are the common fail point
We schedule service calls across Fontana on a rolling basis, and we batch routes so most repairs west of the 15 can be reached the same day you call.
Service Area – Cities Near Fontana
Kensington Gate Repair is based in Montclair and runs gate service across the western Inland Empire. If your property is near the Fontana line, we also cover Bloomington, CA to the south, Rialto, CA to the east, Glen Avon, CA toward the Santa Ana River, and Pedley, CA on the Jurupa side. One call covers all of it.
Serving Fontana, CA — Our Local Coverage Area
We’re based in the Fontana area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Fontana
Most Fontana repair calls are scheduled within the same week, and many within one to two business days. Emergency gate failures that block a driveway or leave a property unsecured get priority scheduling when you call (833) 320-4513 and describe the issue.
Yes. Many newer Fontana communities, especially in 92337, have HOA rules governing gate height, material, color, and operator safety features. We work to the HOA’s written standards and flag any potential conflict before quoting, so you avoid a citation later.
We cover all Fontana ZIP codes plus surrounding cities including Bloomington, Rialto, Glen Avon, and Pedley. If your property is outside Fontana proper but inside the western Inland Empire, call (833) 320-4513 and we will confirm coverage for your street.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Fontana Customers Say
"The loop detector under the driveway had failed and residents were stuck holding the button. He traced it, found the break, and had the exit loop reading cars again the same visit."
— Diego Castillo"We had a hydraulic arm leaking fluid onto the driveway. Replaced, cleaned up the stain as best he could, and it's been dry for months."
— Rosa Delgado"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
— Gilbert Torres